Table of Contents
Advertisement
E
E
Read and follow all instructions and Safety warnings before using this
The FLG5 Gravity Spraygun is fitted with a 1.4mm Nozzle for topcoat applications.
Alternative 2.0mm Nozzle and Needles are available for primer use. The FLG5 Gravity
Feed Spraygun is approved to ATEX regulations 94/9/EC, protection level;
Important: These Sprayguns are suitable for use with both waterbased and solvent
based coating materials. The design uses EPA compliant atomising (Devilbiss Trans-
Tech®) technology to reduce overspray and improve coating efficiency. Nozzles and
Needles are manufactured in Stainless Steel. These guns are not designed for use
with highly corrosive and/or abrasive materials and if used with such materials it must
be expected that the need for cleaning and/or replacement of parts will be increased. If
there is any doubt regarding the suitability of a specific material contact your local
Distributor or ITW Finishing direct.
Air supply connection -
Maximum static air inlet pressure -
Nominal gun inlet pressure with gun triggered - 2.4 bar (35 psi)
Maximum Service temperature -
Gun Weight -
Airflow -
Gun body
Nozzle
Needle
Cup
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
© 2005 ITW Finishing Systems and Products
Operation Manual
FLG5 – Gravity Feed Spraygun
Important
Description
Suitable for use in Zones 1 and 2
SPECIFICATION
Materials of Construction
-
Aluminium
-
Stainless steel
-
Stainless Steel
-
Acetal and Stainless Steel
equipment
II 2 G X
Universal
P
1
40°C
640g
277 l/min (9.8 cfm)
2
1
/
BSP and NPS
4
= 12 bar (175 psi)
Advertisement
Table of Contents
