Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operating Manual
Advertisement
Table of Contents
Related Manuals for DeVilbiss FLG-G5
Summary of Contents for DeVilbiss FLG-G5
- Page 1 SB-E-2-790 ISS.05 OPERATION MANUAL FLG-G5 Transtech Gravity Spraygun 1 – 7 9 – 15 16 – 22 23 – 30...
-
Page 2: Specification
Suitable for use in Zones 1 and 2 Important: These Sprayguns are suitable for use solvent based coating materials. The design uses EPA compliant atomising (Devilbiss Trans-Tech®) technology to reduce overspray and improve coating efficiency. Nozzles and Needles are manufactured in Stainless Steel. -
Page 3: Safety Warnings
SAFETY WARNINGS Always wear protection Fire and explosion when spraying or cleaning the Solvents and coating materials spraygun. can be highly flammable or Gloves must be worn when combustible when sprayed. ALWAYS spraying cleaning refer to the coating material suppliers equipment. - Page 4 Ref. No Part Number Description 1 SGK-0023 Retaining ring 2 FLG-0001-5 Air cap SGK-0012-14 Fluid Tip 1.4mm SGK-0014-18 Fluid Tip 1.8mm SGK-0012-20 Fluid Tip 2.0mm (available separately) ● Gasket ● Baffle Packing Packing gland nut Retaining ring Spray pattern adjustment valve bushing 10 - Spray pattern valve...
- Page 5 © 2005 ITW Finishing Systems and Products...
-
Page 6: Installation
Installation electrical bond from the spraygun to Important: To ensure that this equipment earth should be checked with an reaches first class condition, ohmeter. A resistance of less than protective coatings have been use. Flush Ω is recommended. the equipment through with a suitable solvent before use. -
Page 7: Replacement Of Parts
Replacement of Parts Nozzle (3) and Needle (16) – Remove Remove Rear Airvalve Seal (11) parts in the following order: 18, 17, 16, 1, from housing (15) with a hooked 2 and 3. Check condition of Nozzle Seal instrument. (4) and replace if necessary. Replace any Fit new Seal to Service Tool and Fit worn or damaged parts and re-assemble Seal to Housing (15). -
Page 8: Ec Declaration Of Conformity
EC Declaration of Conformity We: ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the Authorised Representative of the manufacturer of the Spraygun model FLG5, declare, under our sole responsibility, that the equipment to which this document relates is in conformity with the following standards or other normative documents: BS EN 292-1 PARTS 1 &...