Related Manuals for DeVilbiss FLG-G5-14
Summary of Contents for DeVilbiss FLG-G5-14
- Page 1 SB-E-2-790 ISS.02 OPERATION MANUAL FLG-G5-14 Transtech Gravity Spraygun P 1 - 8...
-
Page 2: Specification
Suitable for use in Zones 1 and 2 Important: These Sprayguns are suitable for use with both waterbased and solvent based coating materials. The design uses EPA compliant atomising (Devilbiss Trans- Tech®) technology to reduce overspray and improve coating efficiency. Nozzles and Needles are manufactured in Stainless Steel. -
Page 3: Safety Warnings
SAFETY WARNINGS spraying cleaning Fire and explosion spraygun Solvents and coating materials Gloves must be worn when can be highly flammable or spraying cleaning combustible when sprayed. ALWAYS equipment refer to the coating material suppliers Training – Personnel should be instructions COSHH sheets... - Page 4 Ref. No Part Number Description 1 SGK-0023 Retaining ring 2 FLG-1-5 Air cap SGK-12-14 Fluid Tip 1.4mm SGK-012-20 Fluid Tip 2.0mm (available separately ● Gasket ● Baffle Packing Packing gland nut Retaining ring Spray pattern adjustment valve bushing 10 - Spray pattern valve 11 - U-cup seal...
- Page 5 © 2005 ITW Finishing Systems and Products...
-
Page 6: Installation
Installation Important: To ensure that this equipment electrical bond from the spraygun to reaches first class condition, earth should be checked with an protective coatings have been use. Flush ohmeter. A resistance of less than the equipment through with a suitable Ω... -
Page 7: Replacement Of Parts
Replacement of Parts Nozzle (3) and Needle (16) – Remove Remove Rear Airvalve Seal (11) parts in the following order: 18, 17, 16, 1, from housing (15) with a hooked 2 and 3. Check condition of Nozzle Seal instrument. (4) and replace if necessary. Replace any Fit new Seal to Service Tool and Fit worn or damaged parts and re-assemble Seal to Housing (15). -
Page 8: Ec Declaration Of Conformity
EC Declaration of Conformity We: ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the Authorised Representative of the manufacturer of the Spraygun model FLG5, declare, under our sole responsibility, that the equipment to which this document relates is in conformity with the following standards or other normative documents: BS EN 292-1 PARTS 1 &...