Maintenance - Zodiac Vortex 3.2 Instructions For Installation And Use Manual

5.2 Synchronise the remote control with the control box (in the event of a change of remote /
control box, or both
If equipment is replaced, it is essential to synchronise the remote with the control box.
 Place the remote control about 50 cm away from the control box.
 Connect the control box, check that the display shows the operating time, and that no cleaning cycle is running.
 Switch on the remote by pressing
 Before the remote control puts on hold (around 45 seconds) press the
during 6 seconds.
 Check the synchronisation is correctly completed by looking at the display and the remote control Led :
Control box display
2 seconds
Remaining cycle time
6. Maintenance
6.1 Cleaning the filter
The cleaner performance can be reduced if the filter is full or dirty. Make sure you clean the filter regularly
with clean water for efficient pool cleaning.
 Filter access

 "Clean filter" indicator (Vortex™ 4 4WD)
If the indicator on the control box lights, it is strongly recommended to clean the filter in order to
perfect the cleaning.
If the indicator comes on during a cleaning cycle, it will remain on until the end of the cycle.
H03839‐00.B2 EN – 2013‐09
)
.
Remote Control
LED
Led is blinking
Led is not
flashing
 Synchronisation completed correctly.
 Check the distance between the control box and the remote
control is around 50 cm.
 Check remote control batteries. Change them if necessary.
 If the problem continues contact your reseller.
and buttons simultaneously
Result
10