Advertisement
1.5 Immersing the cleaner
Do not allow bathing when the cleaner is in the pool.
Place the cleaner vertically into the water (1) and move it slightly in all directions so that the air contained in the
cleaner escapes (2).
It is essential that the cleaner sinks on its own and settles on the pool bottom. Spread out the required length of
cable by the pool. For optimum operation we recommend that you place the caddy with the control box at the
centre of the pool length (3).
1.6 Electrical connection
Place the control box on the caddy at a distance of at least 3.5 metres from the edge of the pool
avoiding placing the control box in direct sunlight.
2. Description of the control box
2.1 Vortex
3.2
™
"Control" indicator
Surface area to be cleaned*
Bottom only
Bottom + sides + water line
*The selected cleaning cycle can be identified via the icons that are displayed
H03839‐00.B2 EN – 2013‐09
Unscrew the protective cap.
Connect the floating cable to the control box (1) and lock it into place: firmly tighten
the ring by turning it clockwise (2). Make sure the connector is sufficiently pushed into
place. If this is not the case repeat the operation.
Connect the mains cable. Only connect the control box to a power outlet protected
by a 30 mA maximum ground fault circuit breaker (if in doubt contact a qualified
electrician).
Don't forget to screw the protective cap back on if you unplug the control
box power cord.
Removal from pool mode
Start / Stop the cleaner
4
Hide quick links:
Advertisement
