Section 4. Maintenance; Cord Tangling; Replacing The Brushes - Zodiac CyclonX EM14 Series Owner's Manual

Section 4.
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.
4.1

Cord Tangling

Figure 12. Correct Floating Cable
IMPORTANT
The floating cable may become tangled if correct
procedure is not followed after each cleaning cycle.
After every cleaning cycle:
1. Unplug the fl oating cable from the Control box.
2. Remove the cleaner from the pool and untangle
all kinks and coils in the fl oating cable starting
at the cleaner head (Figure 13).
3. Plug the fl oating cable back into Control box
and store cleaner out of direct sunlight for next
use.
10
Maintenance
Figure 13. Untangle the Floating Cable
4.2

Replacing the Brushes

The cleaner is fi tted with PVC brushes in front and rear.
There are ''wear'' indicators (Figure 14) on the brushes.
To maintain cleaner performance at its best you need
to replace the brush matt as soon as one of the wear
indicators has been reached (even if the bristle wear is
not even). Zodiac Group Australia Pty Ltd recommends
that you replace the brushes every two (2) years.
Figure 14. Wear Indicators
1. Stand the cleaner on its end in a vertical
position (Figure 15).
Figure 15. Stand Cleaner Upright
2. Separate the edges of the brush, undo the tabs,
and remove the worn matt.
H0446500_REVB