Planet ICA-3550V User Manual page 68

accessing the video from the device over the Internet. The router connects to the Internet over
a series of numbered ports. The ports normally used by the device ar
over the Internet. Therefore, these ports need to be made accessible o
accomplished using the Virtual Server function on the router. The Virtual Server ports used b
the camera must be op
F ollow these steps to configure your router's Virtual Server settings
Click Enabled.
Enter a unique name for each entry.
Select Both under Protocol Type (TCP and UDP)
Enter your camera's
Private IP field.
If you are usi
Private Port section
A check mark appearing before
Some ISPs block
open the approp
you will ne ed to chan
as 808 0. Not all routers are the same, so refer to your user manual for specific
instruct ions on how to open ports.
Enter valid ports in the
box on this line to enable setting
WAN IP address.
By now, you have finish
ened through the router for remote access to your camera.
local IP address (e.g., 192.168.0.100, for example) in the
ng the default camera port settings, enter 80 into the P
and click Add.
the entry name will indicate that the ports are enabled.
acc ess to port 80. Be sure to check with your ISP so that you can
riate ports accordingly. If your ISP does not pass traffic on port 80,
ge the port the camera uses from 80 to something else, such
Virtual S erver section of your router. Please make sure to check the
s. Then the device can be accessed from WAN by the router's
ed your entire PC configuration for this device.
68
5 Mega-pixel Outdoor IR PoE IP Camera
e blocked from access
ver the Internet. This is
ICA-3550V
y
ublic and