Planet ICA-3550V User Manual page 39

DHCP
Static IP
IPv6 Assignment
Port Assignment
UPnP
UPnP Port Forwarding
Using DHCP, IP camera will get all the network parameters
automatically.
Please type in IP address, subnet mask, gateway, and DNS
manually.
IPv6 is a newer numbering system that provides a much larger
address pool than IPv4, which accounts for most of today's
Internet traffic. You can se
A ddress, Gateway, and DNS, or enabling DHCP to assign the
I P automatically.
User may need to assign a different port to avoid conflict when
setting up IP assignment.
(1) Web Page Port: setup web page connecting port and video
transmitting port (Default: 80)
( 2) RTSP Port: setup port for RTSP transmitting (Default: 5
( 3) RTP Start and End Port: in RTSP mode, you may use T
and UDP for connecting. TCP connection uses RTSP Port
(554). UDP connection uses RTP Start and End Port.
This IP camera supports UPnP. If this service is enabled on
your computer, the camera will automatically be detected and a
new icon will be added to "My Network Places."
Note: UPnP must be enabled on your computer.
When the camera is installed under a router, enable UPnP
Port Forwarding to let the router open ports so that the video
streams can be sent out from a LAN. Set Web Port, Http Port,
and RTSP port, and make sure your router supports UPnP
and the function has been activated.
39
5 Mega-pixel Outdoor IR PoE IP Camera
t up IPv6 manually by keying in
ICA-3550V
54)
CP