Part Edit Section - Novation SuperNova II User Manual

90-260v, 50-60hz

Hide thumbs Also See for SuperNova II:

Supplementary manual (4 pages)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

131

132

133

134

135

136

137

138

139

140

141

142

143

144

145

146

147

148

Table of Contents

This section contains all the Knobs & buttons associated with the Part Edit Section.

Part 1 - Button

Part 2 - Button

Part 3 - Button

Part 4 - Button

Part 5 - Button

Part 6 - Button

Part 7 - Button

Part 8 - Button

NOTE:

These buttons select "Parts" in Performance Mode. In Program mode they can be used to Audition the currently selected Program.

Simply press the Part buttons & a note will play as long as the button is held down. Part 1 button plays C1, Part 2 button plays F1,

Part 3 button plays C2, Part 4 button plays F2, Part 5 button plays C3, Part 6 button plays F3, Part 7 button plays C4 & Part 8 but-

ton plays F4. Additionally in Program mode these buttons light to display the sequence of steps of an Arpeggiator pattern. ( If the

Arpeggiator is on & playing )

These buttons select which Part of a Performance is going to be edited. Pressing any Part button will assign all the front panel to

the Program assigned to the selected Part. To assign a different Program to this Part use the Bank & Prog Up & Down buttons to

select a new Program. Moving any knob will bring up the Parameter name on the display in the normal way. To return to the dis-

play showing the Part's assigned Program simply press the appropriate Part button again. Any modifications to the Program made

in this mode will have to be written into the Program. See writing Performances into memory on page 37 for details.

NOTE:

Part selection can be transmitted & recorded as controller data to a sequencer & the played back to the Supernova II Rack.

Tune - Button

NOTE:

This button only works in Performance mode.

This button alters the Tuning of the Program assigned to the currently selected Part. When this button is pressed the display shows

parameters relevant to this section.

When this button is pressed the display shows:

Part semitone

Part detune

The higher parameter is "Part semitone". In this case with a value of +07.

This parameter Transposes the Program by the number of semitones selected using the upper Data knob. The range of this para-

meter is -24 to +24 semitones. This parameter is memorised with the Performance.

tune

velocity

output

pedal

midi

polyphony

range

special

+O7

+25

solo

mute

part level

111