Table of Contents
Advertisement
Power On/Off - Switch
This switch turns the mains power supply in the Supernova II Rack on & off.
NOTE:
NOTE:
Edited & newly created Programs & Performances that have not been saved will be lost if the Supernova II Rack is switched off.
Be sure to save edited Programs & Performances to memory before switching Supernova II Rack off. Refer to page 34 & 37 for
details of writing Programs & Performances into memory.
Volume - Knob
This knob adjusts the overall output of the Supernova II Rack on the Left & Right outputs.
NOTE:
NOTE:
This can be overridden by MIDI Controller Data. If a MIDI Controller 97 with a value of "0" has been received by the Supernova II
Rack, no output will be heard regardless of the position of this knob. To reset the volume either transmit the relevant MIDI Volume
level or move the Volume knob. ( This automatically overrides the MIDI setting. )
NOTE:
NOTE:
The volumes of each "Part" in a Performance can be set individually using the Part select buttons & the Level knob in the Part Edit
Section.
Headphones - Socket
Use this 1/4 inch Jack Socket to monitor the Left & Right output of the Supernova II Rack via headphones. This output will drive
any type of headphones.
NOTE:
NOTE:
The Supernova II Racks headphone amplifier will deliver a louder signal if low impedance headphones are used. i.e. 8 ohms
impedance. Be aware that the sound pressure level obtainable with low impedance headphones could damage hearing.
MASTER VOLUME SECTION
power on/off
master volume
headphones
41
Hide quick links:
Advertisement
Table of Contents
