Novation SuperNova II User Manual page 107

NOTE:
NOTE:
No effect will be heard when altering this parameter if the Comb Boost parameter is set to 00
The lower parameter is "Comb boost". In this case with a value of +10.
This parameter adjusts the amount of boost to harmonics the Comb Filter provides . Use the lower Data knob to adjust this para-
meter. If this parameter is set to the mid position ( 00 ) no effect will be heard. If turned Clockwise or anticlockwise from this posi-
tion boost will be applied to harmonics in the sound. The range of this parameter is-64 to +63. This parameter is memorised with a
Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the
Part's "Part FX" parameter.
Page 3 looks like so:
Comb speed
Comb depth
The higher parameter is "Comb speed". In this case with a value of 020.
This parameter adjusts the speed of the Comb filters modulation LFO. Use the upper Data knob to adjust this parameter. The
range of this parameter is 000 to 127. This parameter is memorised with a Program in Program Mode or memorised with a
Program or Performance in Performance Mode depending on the value of the Part's "Part FX" parameter.
The lower parameter is "Comb depth". In this case with a value of 064.
This parameter adjusts the depth of the Comb filters LFO modulation. Use the lower Data knob to adjust this parameter. There are
in fact 2 Comb filters & when this parameter is +ve both Comb filters are modulated with the Comb LFO at the same phase. i.e.
Both going up & down together. When this parameter is -ve both Comb filters are modulated with the Comb LFO in anti phase. i.e.
One going up & the other going down. The amount of modulation determines the depth of the Comb effect.The range of this para-
meter is -63 to +64. This parameter is memorised with a Program in Program Mode or memorised with a Program or Performance
in Performance Mode depending on the value of the Part's "Part FX" parameter.
Page 4 looks like so:
Comb spread
The parameter is "Comb spread". In this case with a value of -20.
There are in fact 2 comb filters. This parameter adjusts the difference in the "Comb frequency" between the two filters. When this
parameter is applied the Comb frequencies of the 2 Comb filters are different & more complex Comb filtering results. This is some-
thing similar to the "Width" parameter in the Special Filter section. Use the upper Data knob to adjust this parameter. When this
parameter is set to 0 both filters are set to the same Comb frequency & they will sound like one comb filter. With +ve settings the
Boost to both Comb filters will be whatever was set on page 2 of this menu. When -ve settings are applied the boost to one of the
Comb filters will be inverted, creating an even more noticeable stereo effect. The range of this parameter is -64 to +63. This para-
meter is memorised with a Program in Program Mode or memorised with a Program or Performance in Performance Mode
depending on the value of the Part's "Part FX" parameter.
O2O
O64
-2O
107
EFFECTS SECTION