Novation SuperNova II User Manual page 48

MODE SECTION
Page 11 looks like so:
Vel sensing
Knob mode
The higher parameter is "Vel sensing". In this case with a value of Hard.
This parameter alters the velocity curve of the Supernova II Rack. Use the upper Data knob to adjust this parameter. This is global
& applies to all modes. In the Hard position, large Velocity changes are required to create a big change in response. This is good
for weighted & semi-weighted master keyboard actions. In the Soft position, not so large Velocity changes are required to create a
big change in response. This is good for cheaper master keyboard actions. The range of this parameter is Hard & Soft. This para-
meter is memorised as Global.
The lower parameter is "Knob mode". In this case with a value of Pickup.
This parameter determines if the values of Knob parameters jumps immediately to the actual position of the Knob as soon as it is
turned or if the Knob has to pass "though" the value of the edited parameter before the knob starts editing the parameter. Use the
lower Data knob to adjust this parameter. In the Normal position the value of the parameter being edited jumps to the value of the
Knob as soon as a knob is turned. This is good when creating sounds as the parameters are always "Live". In the Pickup position
no change to the parameter being edited will take place until the Knob is turned so that the it has passed "through" the value of the
edited parameter, thereby "picking it up". The knob then becomes "live" & will start editing the parameter & will start to transmit the
appropriate controller. The range of this parameter is Normal & Pickup.
NOTE:
NOTE:
When this parameter is set to "Pickup" mode no controller data will be sent & no edits to the parameter by Knob movements will
occur until the Knob parameter has been picked up.
Page 12 looks like so:
Incoming control
change
The parameter is "Incoming control change". In this case with a value of Enabled.
This parameter determines if the Supernova II Rack responds to incoming MIDI controller messages or not. Use the upper Data
knob to adjust this parameter. This filter is global & applies to all modes. The range of this parameter is Enabled & Disabled. This
parameter is memorised as Global.
NOTE: NOTE:
The Incoming Control Change filter does not filter Bank select messages. ( CC00 and CC32 ) These can be filtered using the
Incoming Program Change filter if required.
Page 13 looks like so:
Incoming program
change
The parameter is "Incoming program change". In this case with a value of Enabled.
This parameter determines if the Supernova II Rack responds to incoming MIDI program change messages or not. Use the upper
Data knob to adjust this parameter. When this parameter is set to Enabled any Program Change messages sent on Bank 0 will
refer to the Program Map. This can be overridden by sending Bank & Program Change messages to a different Bank. Refer page
125 for details on the Bank messages received by Supernova II Rack. When this parameter is set to Program map any Program
Change messages will always refer to the Program Change table regardless of any Bank messages that have been received.
Hard
Pickup
Enabled
Enabled
48