Lifting Rod (Right, Ratchet Type); Lifting Rod (Right); Top Link; Telescopic Stabilizers - Kubota B3150 Operator's Manual

BLifting Rod (Right, Ratchet type)
[B3150]
To level a 3-point mounted implement,
1. Press the up and down changing lever.
2. Turn the adjusting handle from side to side to shorten
or lengthen the adjustable lifting rod with the
implement on the ground.
A After adjustment, be sure to lock the adjusting handle
with the handle stopper.
(1) Up and down changing lever
(2) Adjusting handle
(3) Handle stopper
BLifting Rod (Right)
[B3150SU]
Level a 3-point mounted implement from side to side by
turning the adjusting handle to shorten or lengthen the
adjustable lifting rod with the implement on the ground.
After adjustment, tighten the lock nut securely.
(1) Adjusting handle
(2) Lock nut
(A) To shorten the lifting rod
(B) To lengthen the lifting rod
3-POINT HITCH & DRAWBAR
BTop Link
1. Adjust the angle of the implement to the desired
position by shortening or lengthening the top link.
2. The proper length of the top link varies according to
the type of implement being used.
BTelescopic Stabilizers
[B3150]
Adjust the telescopic stabilizers to control horizontal sway
of the implement. Select the proper set of holes by
referring to the "Hydraulic Control Unit Use Reference
Chart" in "AUXILIARY HYDRAULICS" in "HYDRAULIC
UNIT" section.
After aligning satisfactorily, insert the set-pin through any
one of the 8 holes on the outer tube that align with one of
the holes on the inner bar, both stabilizers will be locked.
If the set-pin is inserted through the slot to engage one of
the holes on the inner bar, a limited degree of sway will be
permitted.
(1) Outer tube
(2) Inner bar
(3) Set-pin
(4) Hole
(5) Slot
47