Wiper; Front Wiper / Washer Switch; Rear Wiper Switch; Using The Wipers In Cold Season - Kubota B3150 Operator's Manual

62 CAB OPERATION

WIPER

BFront Wiper / Washer Switch
When the button marked
the wiper only is activated.
When the button is pressed further to the second step,
washer fluid jets out.
The washing continues while the button is pressed and
wiper is activated continuously. (Washer fluid jets out to
the rear window also.)
Hold down the bottom half of the switch when the front
wiper is off, and washer fluid will keep jets out.
To wet the glass before activating the wipers, press the
bottom half of the switch. (Washer fluid jets out to the rear
window also.)

(1) Front wiper / washer switch

is pressed to the first step,
BRear Wiper Switch
1. Press the upper half of the wiper switch, and the wiper
is activated. Press the lower half of the wiper switch,
and the wiper stops at the initial position.
2. To jet washer fluid, push the front wiper / washer
switch. (Washer fluid jets out to the front window also.)

(1) Rear wiper switch

A Do not activate the wipers when the windows are dry,
they may be scratched.
Be sure to jet washer fluid first and then activate the
wipers.
BUsing the Wipers in Cold Season
1. While not used in cold season, keep the wiper blades
off the windshield to prevent them from sticking with
ice.
2. If the windshield is covered with snow, scrape it off the
windshield before using the wipers.
3. If the wiper blades are stuck on the windshield with ice
and fail to move, be sure to turn the main key switch to
"OFF" and remove the ice off the blades. Then place
the main key switch back to "ON".
4. When commercially available cold-season wiper
blades are used, make sure their size is the same as
or smaller than that of the standard ones.
A In cold season, the wiper blades and the wiper motor
might get overloaded causing damage. To avoid this,
be sure to take the above precautions.