3-Point Hitch; Selecting The Holes Of Lifting Rods And Lower Links; Selecting The Top Link Mounting Holes; Drawbar - Kubota B3150 Operator's Manual

46 3-POINT HITCH & DRAWBAR

3-POINT HITCH

1. Make preparations for attaching
implement.
BSelecting the holes of lifting rods and
lower links
There are 2 holes in the lower links. For most operations
the lifting rods should be attached to the (A) holes.
(1) Lower links
(2) Lifting rods
A The lifting rods may be attached to (B) hole for higher
lifting height. (with reduced lifting force)
holes:(A),(B)
BSelecting the Top Link Mounting Holes
Select the proper set of holes by referring to the
"Hydraulic Control Unit Use Reference Chart" in
"HYDRAULIC UNIT" section.
(1) Mounting hole 1
(2) Mounting hole 2
BDrawbar
Remove the drawbar if a close mounted implement is
being attached.
2. Attaching and detaching implements
To avoid personal injury or death:
A Be sure to stop the engine and remove the key.
A Do not stand between tractor and implement
unless parking brake is applied.
A Before attaching or detaching implement,
locate the tractor and implement on a firm, flat
and level surface.
A Whenever an implement or other attachment is
connected to the tractor 3-point hitch, check
full range of operation for interference, binding
or PTO driveline separation.