Hydraulic Control Unit Use Reference Chart - Kubota B3150 Operator's Manual

54 HYDRAULIC UNIT
BHydraulic Control Unit Use Reference Chart
In order to handle the hydraulics properly, the operator must be familiar with the following. Though this information may not
be applicable to all types of implements and soil conditions, it is useful for general conditions.
Implement
Soil condition
Soil condition
Light soil
Moldboard plow Medium soil
Heavy soil
Disc plow ---
Harrower (spike,
springtooth, disc
type)
---
Sub-soiler .........
Weeder, ridger
Earthmover,
digger, scraper,
manure fork, rear
carrier ......
---
Mower (mid-and
rear-mount type),
hayrake, tedder..
Top link mounting holes (1) Position control lever
Top link mounting holes (1) Hydraulic control lever
Hole1
Position control
[B3150SU]
Hydraulic control
*Hole2 is used
only when there
is some obstacle
that prevents you
from using the
hole1.
B3150
Gauge wheel
B3150SU
Gauge wheel
YES/NO
[B3150]
YES
YES/NO
Remarks
Telescopic stabilizers
Remarks
(1) Check chains
[B3150]
Insert the set-pin
through the slot on the
outer tube that align
with one of the holes on
the inner bar.
[B3150SU]
Loose Adjust the check chains
so that the implement
can move 5 to 6 cm (2.0
to 2.4 in.) laterally.
For implements with
gauge wheels, lower the
implements to the
ground.
[B3150]
Telescopic stabilizer
should be tight enough
to prevent excessive
implement movement
when implement is in
raised position.
[B3150SU]
Check chains should be
Tighten
tight enough to prevent
excessive implement
movement when
implement is in raised
position.
For implements with
gauge wheels, lower the
implements to the
ground.