Setting Transition Speed - Simrad GO7 Installation Manual

30
Setting the Transition speed (HI/LO)
This is the speed at which the system automatically changes from
LO to HI steering parameters.
On power boats it is recommended that you set a value that
represents the speed where the hull begins to plane, or the speed
where you change from slow to cruising speed.
On sailboats the transition speed should be set to around 3-4 knots
to give the best response in a tack.
A deadband of 2 knots is incorporated to prevent oscillation of
HI/LO settings when vessel is travelling at the transition speed.
1
HI response
2
LO response
3
Transition to HI parameters with decreasing speed: 8kn
4
Transition speed set to 9kn
5
Transition to LO parameters with increasing speed: 10kn
Active response parameter set is shown in the autopilot popup and
the following abbreviations are used:
HI-A High response parameters set automatically
LO-A Low response parameters set automatically
HI-M High response parameters set manually
LO-M Low response parameter set manually
Software Setup | GO7 Installation Manual