1-2 Preparation
1
1-2-1 Confirming/Setting the Line Number
It is necessary to set a line number to use the UMID. The UMID cannot
be used if the line number is set to 00, the factory setting.
The VANC RX PARAMETER page of the MAINTENANCE menu
allows you to confirm and set the line number for LINE 1 and LINE 2 as
the field where the output line number with be stored. At the factory,
both are preset to 00. If the line number is set to 00, data will not be
output and will not be recorded with the HD (SD) SDI signal.
VANC RX PARAMETER page
LINE 1: Output line number of the first UMID field.
LINE 2: Output line number of the second UMID field.
When it is set to 0, data is not output.
Enter the recommended set number described on the following table, or
the number used in your studio.
1-4
Chapter 1 Using UMID Data