2-6-3 Setting the Built-in Clock Using the GPS
Clock
For a camcorder in which the HKDW-704 has been installed, you can set
the clock built into the camcorder using the GPS clock.
1
Display the TIME/DATE page of the DIAGNOSIS menu.
2
Turn the MENU knob to move the t mark to GPS ADJUST, and
push the MENU knob.
The message "EXECUTE OK? YES t NO" appears.
At this time, the t mark is placed at the left of NO and NO blinks.
3
Turn the MENU knob to move the t mark to YES (YES blinks),
and then push the MENU knob.
The unit runs according to the GPS clock.
Note
The GPS clock information sent is UTC. The clock information is
converted to local time based on the time zone set. Thus, if the time zone
information does not coincide with that of local time, the correct time
will not be displayed.
If the GPS clock does not display the correct local time after GPS
ADJUST operation is finished, reset the time zone.
Chapter 2 Using GPS Data (When Using an HKDW-704)
Local time
2-23
2