Setup Of The Personal Computer Used To Display Shooting Locations - Sony MSW-900 Supplemental Operation Manual

2-5 Setup of the Personal
Computer Used to
Display Shooting
Locations
To display the current shooting location or shooting locations recorded
on a tape on a map, you have to connect the REMOTE connector on the
camcorder and the RS-232C connector of the personal computer on
which mapping software has been installed using a GPS cable (supplied
with an option board HKDW-704).
Also, perform the following setup on the personal computer.
For details, refer to the operation manual supplied with mapping
software.
This section explains the case where Navin'You software has been
installed.
GPS/route guide function setting
Setting of the GPS antenna
Type of GPS card
Communication port COM2 (may differ depending on the personal
Route taken/map match
Route taken
Mapmatch
SONY Corp IPS-5000SERIES
computer)
Records (displays) the route take.
(Set this function to enable by putting a check
mark here.)
Set the map match to enable.
(Disable this function by removing the check
mark.)
Chapter 2 Using GPS Data (When Using an HKDW-704)
2
2-15