d) Select the format according to map software to be used.
For detailed information on the output format, see "Output from the
REMOTE connector" on page 2-20.
2
Turn the MENU knob to move the t mark to the item you want to
set, and then push the MENU knob.
The t mark to the left of the selected item changes to a z mark
and the z mark to the left of the setting changes to a ? mark.
3
Turn the MENU knob to change the setting of the selected item or to
display the desired value, and then push the MENU knob.
The z mark to the left of the selected item changes to a t mark
and the ? mark to the left of the setting changes to a z mark.
4
To continue with the remaining settings, repeat steps 4 and 5.
5
To turn the menu operation off, set the MENU ON/OFF switch to
OFF.
The menu disappears from the viewfinder screen and the display
indicating the current status of the camcorder appears along the top
and bottom of the viewfinder.
Geodetic system
To calculate the location precisely, you should select the number of the
geodetic system which is used for map making in each country on the
GPS DATUM item on the GPS SETUP page. Data calculated for a
different geodetic system will not be correctly displayed on the map.
Refer to "Geodetic System and Areas (for Navin'You)" on page A-6.
Note
The geodetic system which is used in each country may be changed.
Confirm the geodetic system using your map software.
Chapter 2 Using GPS Data (When Using an HKDW-704)
2
2-19