Locking The Osd Menu - Fujitsu P27T-7 Operating Manual

Selecting input signal (D-SUB/DVI-D/HDMI/DP)
► Touch the INPUT
► Touch the ECO
monitor connection (VGA, DVI, HDMI or DP).
► Touch the MENU
This setting window can also be called up when the OSD menu is locked.

Locking the OSD menu

The OSD menu can be locked to prevent accidental or unauthorised changes to the monitor settings.
► Touch the MENU
monitor using the ON/OFF switch.

The message OSD locked / unlocked is displayed.
Please proceed in the same manner to release the locked OSD menu again.
Activate/deactivate ECO operating mode
The power consumption of the device can be decreased by reducing
the brightness of the picture.
► Touch the ECO

The message ECO Mode on or ECO Mode off appears.
If the ECO operating mode is activated, the following OSD settings are changed:
Mode
Colour
Brightness
After the ECO operating mode is switched off, the brightness previously set by the user is restored.
Fujitsu
/ sensor to call up the Input select settings window.
/ or the INPUT
/ sensor to confirm your entries or the
/ sensor for a few seconds while you switch on the
/ sensor to switch the ECO operating mode on or off.
Office
6,500 K
reduced
/ sensor to select the desired
AUTO / sensor to cancel the process.
Operation
21