Alto-Shaam HALO HEAT 500-1D Installation, Operation And Maintenance Instructions page 2

U N PA C K I N G a n d S E T- U P
The Alto-Shaam Drawer Warmer has
been thoroughly tested, checked for
calibration, and inspected to insure only
the highest quality cabinet is provided.
When you receive your unit, check for
any possible shipping damage and
report it at once to the delivering
carrier. See Transportation Damage
and Claims section located in this manual.
Save all the information and instructions packed inside
the cabinet. Complete and return the warranty card to
the factory as soon as possible to assure prompt service
in the event of a warranty parts and labor claim.
NOTE: Any claims for warranty must include the
full model number and serial number of
the cabinet.
H E AT I N G C H A R A C T E R I S T I C S
The drawer warmer is equipped with a special heating
cable. Through this Halo Heat concept, the heating
cable is mounted against the walls of the unit to provide
an evenly applied heat source controlled by a
thermostat. The design and operational characteristics
of the unit eliminate the need for a moisture pan or a
heat circulating fan. Through even heat application,
the quality of food products is maintained up to several
hours or more.
1. Before operating the unit, clean both the interior and exterior of the unit with a damp cloth and mild soap
solution. Rinse carefully.
2. Clean and install the drawer warmer pan(s).
3. Remove drawer pans and clean separately. The drawer assembly is completely removable. Remove from the
cabinet and clean as a sanitation measure, and to prevent a build-up of food residue from interfering with the
function of the drawer assembly.
Regular cleaning will help prolong the life of these parts. After cleaning, lubricate by spraying the bearings with
vegetable release spray.
D R A W E R W A R M E R S
®
®
S TA R T- U P
# 8 1 8 I N S TA L L AT I O N / O P E R AT I O N / S E RV I C E M A N U A L • 1.
E L E C T R I C A L I N S TA L L AT I O N
1. An identification tag is permanently mounted on
the cabinet.
®
2. Plug cabinet into a properly grounded receptacle
ONLY, positioning the unit so the power supply
cord is easily accessible in case of an emergency.
ENSURE POWER SOURCE MATCHES
VOLTAGE S TA M P E D
O N N A M E P L AT E O F U N I T
3. If necessary, a proper receptacle or
outlet configuration as required for this unit,
must be installed by a licensed electrician
in accordance with applicable, local electrical codes.
Disconnect unit from power source
before cleaning or servicing.
At no time should a warming
compartment, drawer assembly
or the unit be steamed cleaned,
washed down or flooded with
water or liquid solution.
Do not use water jet to clean.
Severe damage or electrical
hazard could result
Warranty becomes void if unit is flooded.
3521030
PATENT NOS.
4595247