Enjoy your Alto-Shaam Drawer Warmer! Halo Heat® Soft, gentle Halo Heat® – Alto-Shaam Drawer Warmers use the same soft, gentle Halo Heat that made the Alto-Shaam Cook & Hold oven a kitchen staple all over the world. Product moisture is retained without adding water.
. This manual must be read and understood by all people using or installing the appliance . Contact the Alto-Shaam Tech Team Service Department if you have any questions concerning installation, operation, or maintenance .
. fi led and actively pursued . Alto-Shaam cannot, however, 2 . Do not sign a delivery receipt or a freight bill until fi le any damage claims, assume the responsibility of any a proper count has been made and inspection of all claims, or accept deductions in payment for such claims .
Alto-Shaam of all liability . • Remove all protective plastic fi lm, packaging materials, and accessories from the appliance before connecting electrical power . Store any accessories in a convenient place for future use .
. Operating instructions and warnings must WARNING be read and understood by all operators and users . Alto-Shaam recommends regular staff training to avoid Indicates a hazardous situation that, if not avoided, could the risk of accident or damage to the appliance . Operators result in death or serious injury.
Page 8
If your appliance makes an especially loud noise catch fire. If fat deposits and/or food waste warranty and relieve Alto-Shaam of all liability . when starting up, shut down the appliance and call a inside the appliance ignite, shut down qualifi ed and trained service technician .
Do not store or use gasoline or other experienced workers when moving or flammable vapors or liquids in the vicinity leveling appliance and handling accessories. of this or any other appliance. This Alto-Shaam Minimum Clearance Requirements appliance must be Back 3" (76mm) ®...
Electrical Connection 1 . An identification tag is permanently mounted on the This section is provided for the assistance of Drawer Warmer . qualified and trained service technicians only 2 . Plug Drawer Warmer into a properly grounded and is not intended for use by untrained or receptacle only, positioning the unit so the power unauthorized service personnel.
Operation Before initial use: Food Product Tips Clean both the interior and exterior of the unit with a Bread and Rolls clean, damp cloth and mild soap solution . Rinse carefully . Breads and rolls are traditionally difficult to hold for Clean and install the drawer warmer pan(s) .
Page 14
Operation 1. Preheat Drawer Warmer at 200°F (93°C) for 30 minutes 5 . Check to ensure the drawers are securely closed, before loading hot food. and use the Up Arrow or Down Arrow to set the temperature to 160°F (71°C) . Push power switch to the On position .
General Holding Guidelines Chefs, cooks and other specialized food service personnel Holding Temperature Range employ varied methods of cooking . Proper holding Meat Fahrenheit Celsius temperatures for a specific food product must be based Beef Roast — Rare 130°F 54°C on the moisture content of the product, product density, Beef Roast —...
If further extinguishing is required, disconnect the appliance from the main power and call the fire department. Failure to clean the appliance properly voids the warranty and relieves Alto-Shaam of all liability. MN-29742 • Rev 10 • 08/18 • Drawer Warmers...
Page 17
Cleaning and Preventative Maintenance WARNING WARNING To prevent serious personal injury, death, or To prevent serious injury, death, or property damage, always disconnect the appliance property damage: from the power source before cleaning Do not steam clean, hose down or flood the or servicing.
Food Safety Food fl avor and aroma are usually so closely related that it Internal Food Product Temperatures is diffi cult, if not impossible, to separate them . There is also Hot Foods an important, inseparable relationship between cleanliness Danger Zone 40°F to 140°F 4°C to 60°C and food fl avor .
* Check main power circuit breaker to the unit and verify that the circuit breaker on the back of the unit is turned on, if applicable . Do not attempt to repair or service the unit beyond this point . Contact Alto-Shaam for the nearest authorized service agent. Repairs made by any other service agents without prior authorization by Alto-Shaam will void ®...
Page 20
Troubleshooting Code Description Possible Cause s E-10 Cavity air sensor shorted Cavity air sensor reading < 5°F (-15°C) . Verify sensor integrity . E-11 Cavity air sensor open Cavity air sensor reading > 517°F (269°C) . Verify sensor integrity . Product probe is shorted E-20 Product probe reading <...
Service 500-D Exterior 30 18 Part numbers and drawings are subject to change without notice . For builds prior to August 1, 2018, please consult the Alto-Shaam website (alto-shaam.com) MN-29742 • Rev 10 • 08/18 • Drawer Warmers...
Page 22
SCREW, SOCKET, SHOULDER 1/4-20" BG-24890 Bearing * not shown Part numbers and drawings are subject to change without notice . For builds prior to August 1, 2018, please consult the Alto-Shaam website (alto-shaam.com) MN-29742 • Rev 10 • 08/18 • Drawer Warmers...
Page 24
For builds prior to August 1, 2018, please consult the Alto-Shaam website (alto-shaam.com) MN-29742 • Rev 10 • 08/18 • Drawer Warmers...
Page 25
NUT, 1/4-20, KEPS, S/S SC-39699 SCREW, SOCKET, SHOULDER 1/4-20" Part numbers and drawings are subject to change without notice . For builds prior to August 1, 2018, please consult the Alto-Shaam website (alto-shaam.com) MN-29742 • Rev 10 • 08/18 • Drawer Warmers...
Page 26
1019169 VENT SLIDE 1012804 OUTER DRAWER non-vented drawer 1012901 vented drawer RI-2100 RIVET, BLIND, #44, S/S For builds prior to August 1, 2018, please consult the Alto-Shaam website (alto-shaam.com) MN-29742 • Rev 10 • 08/18 • Drawer Warmers...
Page 27
Service 500-D, 500-DN Electrical Item Part Description Item Part Description CC-34970 WARMER CONTROL WS-22297 WASHER, FLAT CR-34967 CONNECTOR-2 CONDUCTOR SC-36973 SCREW, PAN PH, METRIC, M5 SW-34769 SWITCH, ROCKER, 125-277V, 20A WS-22302 WASHER, SPLIT LOCK SP-29392 SPACER, SNAP-IN, 7/16 BU-3964 BUSHING, STRAIGHT, STRAIN RELIEF 1003936 HI-LIMIT PROTECTION COVER 5015002...
Page 28
Service 500-2DI Exterior Part numbers and drawings are subject to change without notice . MN-29742 • Rev 10 • 08/18 • Drawer Warmers...
Page 29
Service 500-2DI Exterior Parts List Item Part No. Description 1003936 HI-LIMIT PROTECTION COVER 1012473 COVER, TOP 1012667 PANEL, INNER BACK 1017521 INSULATION, BOTTOM, 1017529 INSULATION,BACK 1022418 INSULATION,TOP 1025247 BRACKET, OFFSET, TERMINAL 1025252 INSUL, SIDE, 7.750" x 22.485" 1026119 CASING, OUTER 1026121 TRIM, REAR 1493...
Page 30
Service 500-2DI Electrical Item Part No. Description CC-34970 CONTROL CR-34967 CONNECTOR-2 CONDUCTOR SW-34769 SWITCH, ROCKER, 125-277V, 20A SP-29392 SPACER, SNAP-IN, 7/16” 1003936 HI-LIMIT PROTECTION COVER SC-22271 SCREW, M4-0.7 x 6mm PHIL TT-33476 THERMOSTAT, 300F HI-LIMIT BK-3019 T-BLOCK NU-22770 NUT, THREADED INSERT, M6 SC-22924 HHCS, M6 x 20, W/NO MARKING SC-2365...
This warranty is exclusive and is in lieu of all other warranties, express or implied, including the implied warranties of merchantability and fi tness for a particular purpose . In no event shall Alto-Shaam be liable for loss of use, loss of revenue or profi t, or loss of product, or for any indirect, special, incidental, or consequential damages .