Advertisement
www.aeroplusrc.com
Drill a hole in the base of the rudder for the rudder steering guide.
Before gluing with C.A. glue, place it over the thin rod.
Aileron Servos
The ailerons on the wings are pre-glued. Check each one by gently pulling to make sure that they
are secure
Remove the covering where the aileron horns are glued in place. Use either a soldering iron or a
sharp knife
Using sand paper rough the area that will be glued into the aileron.
Glue both horns in with epoxy glue; use a bolt through the horns when gluing to make sure the
alignment is correct.
Fit the aileron servo and drill fine holes where the servo screws will fit. Then apply thin to
strengthen the holes.
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
