Advertisement
www.aeroplusrc.com
Landing Gear Assembly
To help prevent the fuselage from being damaged while the model is being assembled we
recommend fitting the landing gear first.
Note - Before beginning assembly be sure to determine your left and right wheels pants.
First, glue the thin wood wheel spacer to the inside of the wheel pant on what will be the outer side
of the pant. Use the bolt to help centre the spacer
Next, insert the bolt from what will be the outside of the wheel pant; put one thicker wood spacer
on to the axle bolt, followed by the wheel and one more wood spacer.
Install a lock washer onto the axle-bolt, followed by a washer.
Note- you must place the washer now as it will be impossible to place once the axle is tightened.
Tighten down the bolt holding the locknut.
Note – Do not over tighten. This will prevent the wheel from turning.
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
