Advertisement
www.aeroplusrc.com
The closed loop wires are assembled in the plane; attach the rear ball joints to the rudder. Do this
to both sides.
Fit the arm onto the rudder servo and crimp the wires to a taut tension
Tail Gear
Locate all parts as in picture. When assembling, remember to do a thread locker on all parts
Assemble the Gear as per photo
At the rear of the fuselage you will find a ply wood area, lay the CF gear on this and mark the 3
holes, taking care to make sure it is straight.
Drill each hole with a fine drill and drop thin C.A glue into the holes to strengthen the wood.
Screw the CF gear on with the three supplied self-taping screws.
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
