Advertisement
www.aeroplusrc.com
Glue the horns in place using epoxy glue. Put a bolt through the ball joint hole to make sure that
the horns stay in alignment while drying.
Before fitting the elevator servo fix an extension lead so that the wire can be routed through the
cardboard tube wire holder in the fuselage. Be sure to secure the coupling.
Remove the covering for the elevator servo
Fit the Elevator Servo and, using a fine drill, drill holes for the servo screws. Remove the servo and
drop thin C.A. into all 4 holes after first threading the servo.
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
