Advertisement
www.aeroplusrc.com
A convenient place to mount the RX is just in front of the rudder servo. Ensure that it is mounted
on Velcro and strapped down.
Canopy
The canopy is held in place with the 2 thumb screws. Ensure these are tight before flying
Set-up
We highly recommend the use of both dual rates and exponential. This will allow the model to fly both
precision and 3D at the flip of a switch.
Low Rates
Elevator
15-20 deg
Ailerons
15-20 deg
Rudder 25-30 deg
For test flights always use low rates; remember that + and – exponential is different per manufacturer.
Check your TX manual.
Always check the range on your model before the maiden flight. Carry out a short flight then go over
everything to make sure nothing has come loose.
CG Location
We suggest for initial test flights that you set the CG 118mm or 4 5/8 inches from the leading edge of the
wing.
Adjust after first flights to personal preference.
Exponential
High Rate
15-20 %
15-20 %
15-20 %
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Exponential
35-45 deg
35-45 deg
35-45 deg
45-60 %
45-60 %
45-60 %
Advertisement
