Advertisement
www.aeroplusrc.com
Insert the protruding bolts through the landing gear hole.
Tighten up using a washer and lock nut.
Repeat for other side.
Horizontal Stab
First, remove the covering where the elevator horns fit into the stab, use either a soldering iron or a
sharp hobby knife.
Test fit the horns before gluing; some adjustment may be needed.
The area of the horns that goes inside the elevator needs to be roughed up with sandpaper before
gluing. This will result in a better glue joint.
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
