Advertisement
www.aeroplusrc.com
Re-fit the elevator servo and secure it in with servo screws after the. Glue fully dries.
Centre the servo using your TX, and fit a servo arm. Use either an aftermarket arm or attach the
arms that were supplied to a servo head. Screw ball joints onto the pushrod (use pliers to hold
pushrod) and bolt in place with supplied bolts. Centre of servo should align with elevator flat to the
stab.
Rudder
Remove the covering where the rudder horns push through with either a knife or soldering iron.
Test fit the rudder horns
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
