Advertisement
www.aeroplusrc.com
Sand the area on the horn that fits inside the rudder so the glue bonds better
Glue the rudder hinges into both the rudder and fin using epoxy glue. Remember to use Vaseline
on the hinge joint. While drying, use tape to keep it in alignment.
Glue the rudder horns through the rudder with epoxy; wipe off excess glue while it is wet. Use the
ball joint and bolt while gluing to maintain alignment. While still movable, measure that the same
amount pushes out each side. Care needs to be taken here, otherwise your rudder geometry will
be incorrect.
Assemble the rudder servo control arm as below, drill holes for screws and use C.A glue to stop the
nuts from coming loose.
Fit the rudder servo and drill holes using a fine drill for the servo screws; drop thin C.A glue into the
holes to strengthen the wood.
Using servo screws, fix the servo in place; note that the spline is towards the front of the plane
Aero Plus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
