Roland VersaCamm VS-640 Setup Manual page 42

6. Installing the Blade
3.
Install the blade holder.


Insert until the
collar is flush
with the surface.
w
x
Important Note on the Handling and Use of the Cutting Carriage
While the blade holder is not attached, leave the screws of the cutting carriage loose. If you leave them
tightened firmly, the hole to insert the blade holder is gradually getting smaller, which will make it difficult
to attach the blade holder.
40
Screw
Screw
Support it from below.
Screw
Close the front cover, and then press
Loosen the screw as shown in the figure.
Support the screw from below and insert
the blade holder.
If you install the blade holder without supporting
the screw from below, the cutting quality may be
deteriorated.
Tighten the screw.
Pull the blade holder upward to make sure it does
not come off.
.