Replacing The Master Roll - Riso RISOGRAPH RN2000 User Manual

Replacing the Master
Roll
Raise the Scanner Table.
1
Hold the Scanner Table Release Lever and raise
the Scanner Table until it stops.
Open the Master Roll Cover.
2
Pull down the Master Roll Cover.
Open the Master Making Unit.
3
Open the Master Making Unit by pulling down the
green Master Making Unit Release Lever, which
is located on the right side of the unit.
Remove the depleted Master Roll.
4
Pull the depleted Master Roll toward you and
remove it from the supporter.
Remove both left and right
5
flanges.
Remove both left and right flanges from the
depleted Master Roll.
98