Notes On Connections - T+A Cala User Manual

 
 
Changing the
batteries
   
 
 
Care of the
unit

Notes on connections:

• Be sure to push all plugs firmly into their sockets. Loose connections
can cause hum and other unwanted noises.
• When you connect the input sockets of the 
the source devices always connect like to like, i. e. 'R' to 'R' and 'L' to 'L'.
If you fail to heed this then the stereo channels will be reversed.
• To achieve maximum possible interference rejection the mains plug
should be connected to the mains socket in such a way that phase is
connected to the mains socket contact marked with a dot ( ). The
phase of the mains socket can be determined using a special meter. If
you are not sure about this, please ask your specialist dealer.
If you encounter problems when setting up and using the amplifier for the
first time please remember that the cause is often simple, and equally
simple to eliminate. Please refer to the section of these instructions
entitled 'Trouble shooting'.
The battery compartment of the F100 can be opened by pressing in the
locking surface and sliding the cover down and off. Remove the old cells
and fit two new dry cells of the LR 03 (MICRO) type in the battery
compartment, taking care to fit them with correct polarity. Please
remember that all the cells must be replaced at the same time.
Caution!
Batteries shout not be exposed to excessive heat like sunshine, fire or
the like.
Disposing of exhausted batteries:
Exhausted batteries must never be thrown into the household
waste! They should be returned to the battery vendor (specialist dealer)
or your local toxic waste collection point, so that they can be recycled or
disposed in a proper way. Most local authorities provide collection
centres for such waste, and some provide pick-up vehicles for old
batteries.
Always disconnect the unit from the mains supply before cleaning it.
The surfaces of the case should be wiped clean with a soft, dry cloth
only.
Never use solvent-based or abrasive cleaners because the acrylic glass
could be damaged!
Before switching the unit on again, check that there are no short-circuits
at the connections, and that all cables are plugged in correctly.
69
 to the output sockets on
 