Entering the
Password
(for encoded
networks)
Storing
Network
Settings and
Restarting
Special case:
Manual
Network Entry
If your network is encoded, the window illustrated above now appears.
Please enter the network password and confirm the entry by pressing
. Now select the point 'Save WLAN settings' and confirm with
.
If a WEP code is used, the password must be entered as a hexadecimal
code (0 - 9, A - F).
Please enter the settings for the remaining network parameters as
described earlier in the section entitled 'Setting the Parameters for a
Wired Network'.
Finally select the menu point 'Save and Restart', and press the
button; this action accepts the settings, and restarts the
new settings.
The
automatically searches for accessible radio networks, and lists
them when you call up the menu point 'WLAN Configuration'. However,
the
can only locate networks which broadcast their SSID network
identity. For security reasons many radio networks do not transmit the
SSID (if you are not sure about this, ask your network administrator). In
such cases the network cannot be found and displayed automatically, i.e.
it must be set up manually. This is the purpose of the menu point 'Set
Manually'. If you select this menu point, you will see the input window
reproduced below; you can enter the parameters for your network at this
point.
After successfully entering all the data, please select the point 'Save
WLAN Settings', and confirm by pressing the button. Your
now accepts the data you have entered relating to the WLAN network,
and moves on to the subordinate menu in which you can set the
remaining network parameters, as described earlier in the section entitled
'Setting the Parameters for a Wired Network'.
You can now leave the Configuration menu by selecting the menu point
'Save and restart'.
77
with the