Trouble-Shooting - T+A Cala User Manual

Many problems have a simple cause and a correspondingly simple solution. The following
section describes a few difficulties you may encounter, and the measures you need to take to
cure them. If you find it impossible to solve a problem with the help of these notes please
disconnect the unit from the mains and ask your authorised  specialist dealer for advice.
Machine does not switch
on
Machine cannot be
controlled by IR remote
control.
The streaming client
cannot connect to a
network.
On the display the
indication
'SCL Connecting...'
is displayed.
Trouble shooting
Cause 1:
Mains lead not plugged in correctly.
Remedy:
Check connection, push connector in firmly.
Cause 1:
Incorrectly inserted batteries or flat batteries in the remote
control handset.
Remedy:
Re-install batteries correctly or fit new ones.
Cause 2:
The remote control transmitter has no direct line-of-sight with
the unit.
Remedy:
Make sure that the remote control transmitter has direct line-of-
sight contact with the receiver - note that glass doors can
interrupt the connection.
Maximum range between transmitter and receiver: approx.
8 metres.
Be sure to position the receiver where it is not subjected to
direct sunlight or very bright artificial light. Fluorescent tubes
and energy-saving lamps are powerful sources of interference.
Cause 1 (cable LAN):
Network cable not properly connected
Remedy:
Connect network cable, check connection to router
Cause 2 (wireless LAN):
WLAN antenna not connected or placed in a location with bad
reception quality
Remedy:
Connect WLAN antenna properly and find a location with good
reception quality.
Set the transmission power output of your WLAN router to
maximum.
Try to establish a network connection first in a location close to
the WLAN router. If this succeeded try to connect to WLAN
from a more remote location. Experiment with antenna position
and try to find a location with better reception quality.
80