T+A Cala User Manual page 52

Sub-point
Speaker
LF Shape
Sub-point
SPK stand ...
Sub-point
Subwoofer
Menu point
Source
configuration
Changing the
source name
Input level
Auto power-on
 
 
In this menu point you can set the loudspeaker type and, if appropriate,
the cross-over frequency between the main loudspeakers (loudspeaker
group A - left / right) and the sub-woofer.
If you are using large loudspeakers, please choose the "FULL RANGE"
setting. For relatively small satellite speakers we suggest that you
choose a cross-over frequency of 40Hz, 60Hz, 100Hz or 150Hz,
depending on the size and bass performance of your loudspeakers.
This is the basic rule: the smaller the speaker cabinet, the higher the
cross-over frequency
recommended for small loudspeakers such as small bookshelf units, if
they are operated without a sub-woofer. At this setting the bass range of
the speaker is extended to low frequencies.
If loudspeakers are set up close to a wall or a corner, the result may be a
disproportionate boost to the low frequencies. To compensate for this
effect please select one of the set-up options
free / near to wall / in a corner / shelf,
according to the location of your loudspeakers.
In this menu point you can set the cross-over frequency for your sub-
woofer. If your system does not include a sub-woofer, you should choose
the "OFF" setting.
At this menu point you can change the settings for the external sources.
An unrestricted name in plain text can be assigned to any external
source, which is then used in the screen display.
The input for sources A1 IN and A2 IN can be adjusted to suit the output
level of the device connected to these sockets. It is also possible to
activate the automatic power-on function for one of these sources.
If you wish to change the plain text name, move to the appropriate line
and press the  button. Change the name to the one you prefer,
and confirm with . This action stores the settings for that source.
The input level can be set to any of four values. Set the input in such a
way that the volume matches that of the 
confirm your choice with the  button. This action saves the
settings for that source.
At this menu point you can activate the automatic power-on function for
one of the sources A1 IN or A2 IN.
If the function is switched on the 
from stand-by when a music signal is detected at the selected input.
If the connected device is switched off the 
after about twenty minutes.
In this mode of operation the volume level for the selected source is
controlled and stored separately, and is only changed when that source
is selected. However, this only occurs if you have selected the source for
which this function has been set.
This mode of operation can be used for example to switch the 
and off in combination with a connected TV set.
This function is only possible if the 'Comfort stand-by' mode has been
selected and is indicated in standby and operation mode in the lower
right corner of the screen.
should be. The
 's internal sources, then
 
 switches itself on automatically
 
52
"Bass extd." setting
 switches itself off too
 
 on
 
is