Energizer EZG1300 User Manual page 20

4.3 Using the EZG1300 to Charge Automotive Batteries
You can use 12V 8.3A DC output to charge automotive batteries. Be sure to
monitor the battery charge time.
Over-charge may cause explosion and injury.
An explosive hydrogen gas is discharged through vent holes in the battery
during charging. Do not allow sparks or open flames around the generator
or battery during the charging process.
Electrolyte fluid can burn eyes and clothing. Be extremely careful to avoid
any contact. If injured, wash the affected area immediately with large
amounts of water and seek medical attention immediately.
1. Connect the positive (red) terminal of the battery to
the red (positive) terminal, the 12V 8.3A DC Output
Terminal on the front panel of your generator.
2. Connect the negative (black) terminal of the battery
to the black (negative) terminal, the 12V 8.3A DC
output terminal on the front panel of your generator.
DO NOT REVERSE THE POLARITY OF THESE
CONNECTIONS.
3. Plug in the DC plug into the DC receptacle.
Start the generator as instructed in Section 4.2
20