Energizer EZG1300 User Manual page 19

4.2 Using the EZG1300 with your Appliances
After starting the eZG1300 you can connect your devices to it. If you want to use the
DC output to charge an automotive battery, skip to section 4.4. Before starting make
sure that you know what you are able to power with your Generator. Here's how you
can decide:
Add the watt ratings of all the loads that the generator set will be powering at the same
time. Make sure that total wattage will not exceed the generator rating.
EXAMPLE:
A generator set rated 5000W can power two 1500W heaters, a 900W circular saw, a
500W drill and a 100W light at the same time (4500W combined). However, to operate
a second 900W saw, it will be necessary to disconnect one of the 1500 W heaters.
To stop the engine in an emergency, turn the engine switch "OFF". Always
connect the ground terminal at the front panel to the ground (earth) to
prevent electrical shock.
1. Turn off the switches of devices before
before connecting them to your generator.
2. Insert the plug of the device into your generator
based on its voltage requirements. Your eZG1300
generator includes two (2) 120V AC outlets and one
(1) DC outlet for charging automotive batteries.
See Section 4.4 before using the DC outlet
3. You can now turn your devices on and use them.
19
series