Ketra N3 Installation Manual page 14

Overview of Third Party Controls:
The class 2 control input/output compartment enables interface with
numerous devices. Choose appropriate terminals based upon your
application.
Sections Include:
Analog I/O
This section contains four ports. Each port can be configured
independently to be any of the following control types (refer to
applicable protocol wiring diagrams):
• Contact closure input
• Contact closure output
• 0-10V input
• 0-10V output
0-24V input
•
DMX
This section contains two ports: "DMX In" and "DMX Out/Thru."
"DMX Out/Thru" can be configured to either pass through
"DMX In" signal or operate as a stand-alone DMX universe of
control. Refer to applicable protocol wiring diagrams.
If only "DMX In" is being used, make sure DMX Connection toggle switch
is set to "Terminated."
PAGE 14
I N S TA LL ATI O N
770-000014-01-01
N3
INSTALLATION INSTRUCTIONS