Ketra N3 Installation Manual page 12

!
TO TERMINALS MARKED "TRIAC CONTROL."
AC Output Wiring Procedure:
1. Connect power and signal output to G2 Linear luminaires.
Note: Details on G2 Linear connections available in G2
Installation Guide.
2. Open appropriate terminals by flipping orange levers into UP
position. (see fig. 8)
Make connections to the "Power and Signal OUT" section;
connecting to appropriate line, neutral, and ground terminals.
(Note: wire strip length is 12mm/.47 inches.)
3. Insert appropriate conductors from G2 leader
(see fig. 9)
Black conductor goes to "L" terminal.
White conductor goes to "N" terminal.
Green conductor goes to "
Red conductor goes to "S" terminal.
Note: Conductor colors are not always as listed. These colors vary
depending on your wiring setup. To ensure the correct wiring, consult a
PAGE 12
I N S TA LL ATI O N
WARNING: DO NOT CONNECT AC SUPPLY
professional electrician.
" terminal.
770-000014-01-01
cable.
N3
INSTALLATION INSTRUCTIONS
!