Ketra N3 Installation Manual page 10

5
!
TO TERMINALS MARKED "TRIAC CONTROL."
AC Input Wiring Procedure:
1. Connect AC supply.
Use conduit or NM type cable as appropriate. (Note: acceptable
wire is both solid core and stranded. Gauge range is 10-16
AWG.)
2. Open appropriate terminals by flipping orange levers into UP
position. (see fig. 6)
Make connections to the "AC Mains Power In" section; connecting to
appropriate line, neutral, and ground terminals. (Note: wire
strip length is 12mm/.47 inches.)
3. Insert appropriate conductors from AC Mains Power. (see fig. 7)
Black conductor goes to "L" terminal.
White conductor goes to "N" terminal.
Green conductor goes to "
Note: Conductor colors are not always as listed. These colors vary
depending on your wiring setup. To ensure the correct wiring, consult a
PAGE 10
I N S TA LL ATI O N
Mounting Holes
3/16 inch hole
WARNING: DO NOT CONNECT AC SUPPLY
professional electrician.
" terminal.
770-000014-01-01
!
N3
INSTALLATION INSTRUCTIONS