Rear View - Arris NVG599 Administrator's Manual

LED
Solid Green
WPS
utes or until push button is pressed again.
(appears after
Flashing Green
using WPS
Flashing Red
button)
risk).
Solid Red
should stay solid red for 5 minutes or until push button is pressed again.
Off = The device is is ready for WPS authentication.

Rear View

Reset
Power Jack
LED
Flashing Amber
Ethernet Solid Green
1, 2, 3, 4
Flickering Green
Off = The device is not powered, or no powered devices are connected to the associated ports.
NOTE:
The NVG599 supports two VoIP lines over one RJ14 (FXS) VoIP port. In order to
connect two phone lines, the supplied inner/outer pair splitter adapters must
be attached to the RJ14 (FXS) VoIP port in order to terminate both lines. This is
a special-purpose splitter. You must use only the inner/outer pair splitter
adapters supplied by AT&T.
= Wi-Fi Protected Setup has been completed successfully. LED should stay on for 5 min-
= Continues for 2 minutes, indicating when WPS is broadcasting.
= Continues for 2 minutes, indicating a Session overlap was detected (possible security
= Error unrelated to security, such as failure to find a partner, or WPS is disabled. LED
F-Connector (HPNA)
RJ14 (FXS) Ethernet (LAN)
= A Gigabit Ethernet device is connected to each port.
= A 10/100 Ethernet device is connected.
= Ethernet traffic activity.
Activity
DSL (WAN) Gigabit Ethernet (WAN)
USB
Activity
15