Clear A Paper Jam In The Top Cover Of The Stacker/Stapler - Canon AK1 Operation Manual

Clear a paper jam in the top cover of the stacker/stapler

Introduction
If a paper jam occurs in the top cover of the stacker/stapler (Finisher-AK1/Saddle Finisher-AK2),
the control panel will display the location of the paper jam and the procedure to clear the paper
jam. Follow the instructions on the control panel to clear the paper jam. The procedure below
describes how to clear a paper jam in the top cover of the stacker/stapler.
CAUTION
• When you remove jammed originals or paper, take care not to cut your hands on the edges
of the originals or paper.
• When you remove jammed originals or paper, take care not to cut your hands on the inside
of the machine. If you cannot remove the paper, contact your local authorized dealer.
• Be careful when you handle the optional units that are attached to the machine. When you
open the door or cover of an optional unit to replace a staple cartridge, discard the punch
waste, or clear paper jams or staple jams, prints may still be output if other optional units are
operating normally, and are not involved in the paper or staple jam removal procedure.
NOTE
If the inserter (Document Insertion Unit-F1) is adjacently attached to the stacker/stapler, the part
of the inserter may interfere with the stacker/stapler when you clear jams. Lift up the inserter
before you clear jams in the stacker/stapler.
Clear a paper jam
Step Action
1 Open the front door of the stacker/stapler.
2 Press the button (F-A1) on the optional
Puncher Unit-BT1/BU1, as far as possible.
3 Open the guide (F-A2).
Canon Finisher-AK1/Saddle Finisher-AK2/Puncher Unit-BT1/BU1
NOTE
This procedure is only required
when the optional Puncher
Unit-BT1/BU1 is attached.
Clear a paper jam in the top cover of the stacker/stapler
Illustration
Chapter 4 - Troubleshooting
4
33