Download  Print this page

Remove The Puncher Waste Box - Canon AK1 Operation Manual

Finisher-ak1 saddle finisher-ak2 puncher unit-bt1-bu1
Hide thumbs

Advertisement

Remove the puncher waste box

CAUTION
Be careful when you handle optional units that are attached to the machine. When you open
the door or cover of an optional unit to replace a staple cartridge, discard the punch waste, or
clear paper jams or staple jams, prints may still be output if other optional units are operating
normally, and are not involved in the paper or staple jam removal procedure.
NOTE
When the puncher waste box is full, you cannot use the punch function when you perform a
copy job or print job.
Remove the punch waste box
Step
Action
1
Open the front door of the stacker/stapler.
2
Pull out the puncher waste box.
3
Discard the punch waste into a common
dustbin.
4
Put the puncher waste box back.
Make sure that you insert the puncher
waste box as far as possible.
Canon Finisher-AK1/Saddle Finisher-AK2/Puncher Unit-BT1/BU1
Operation Guide Finisher-AK1, Saddle Finisher-AK2, Puncher Unit-BT1-BU1: VarioPrint (VP) 110, VP120, VP135 - Edition 2013-06
NOTE
If the puncher waste box is not
securely in place, you cannot
use the punch function when
you carry out a copy job or print
job.
Remove the puncher waste box
Illustration
Chapter 3 - Use the stacker/stapler
4
27

Advertisement

Table of Contents
loading

  Also See for Canon AK1

This manual is also suitable for:

Bu1Ak2Bt1