Replace The Staple Cartridge Of The Saddle Stitch Unit (Staple P1) - Canon AK1 Operation Manual

Replace the staple cartridge of the saddle stitch unit
(Staple P1)
Introduction
When a staple cartridge of the saddle stitch unit of the optional Saddle Finisher is almost empty,
the control panel will display a message indicating which staple cartridge must be replaced. The
procedure below describes how to replace the staple cartridge.
NOTE
This procedure is only necessary when the Saddle Finisher is attached.
Required staples
Staple P1
NOTE
You can order all required supplies from your local authorized dealer.
Replace the staple cartridge of the saddle stitch unit
Step Action
1 Open the front door of the stacker/stapler.
2 Pull out the saddle stitch unit.
3 Grab the tab of the staple case and pull
the staple case out of the staple unit.
4 Hold the cover of the staple case by its
left and right sides
Lift the cover and slide the cover off.
Canon Finisher-AK1/Saddle Finisher-AK2/Puncher Unit-BT1/BU1
Operation Guide Finisher-AK1, Saddle Finisher-AK2, Puncher Unit-BT1-BU1: VarioPrint (VP) 110, VP120, VP135 - Edition 2013-06

Replace the staple cartridge of the saddle stitch unit (Staple P1)

Illustration
Chapter 3 - Use the stacker/stapler
4
25