Canon AK1 Operation Manual page 19

Custom size
* Custom paper sizes can only be output if they are between 210 mm x 279.4 mm to 330.2 mm x
487.7 mm (8.3" x 11" to 13" x 19.2").
NOTE
You can only use the booklet tray when Saddle Finisher-AK2 is installed.
High-volume mode
The Settings Editor on the PRISMAsync controller contains a [High-volume mode enabled]
setting. When this setting is set to [Yes] the upper tray and the lower tray of the stacker/stapler
will be linked to increase the output capacity for non-stapled jobs. The total output capacity will
become 5,000 sheets for 80 g/m² / 20 lb bond media (3,000 sheets in the upper tray and 2,000
sheets in the lower tray).
NOTE
The mode is not active when trimmer D1 is present.
• You can still select the lower tray or upper tray as desired output location but the system
ignores the choice.
• First the lower tray will be filled, then the upper tray.
• When both trays are full, you must first empty the trays before printing continues.
• When stapling is required, the trays will be filled to their normal capacity (3,000 sheets).
Canon Finisher-AK1/Saddle Finisher-AK2/Puncher Unit-BT1/BU1
Operation Guide Finisher-AK1, Saddle Finisher-AK2, Puncher Unit-BT1-BU1: VarioPrint (VP) 110, VP120, VP135 - Edition 2013-06
Paper size
A4R/LTRR
182 mm x 182 mm to
330.2 mm x 487.7 mm /
7.2" x 7.2" to 13" x 19.2"
Output tray
Upper tray Lower tray
Yes Yes
Yes Yes
Chapter 3 - Use the stacker/stapler
The finishing modes
Booklet tray
Yes
Yes *
19