Western Digital ShareSpace User Manual page 96

To replace an internal drive:
1. Turn off the system and all the peripherals connected to it.
2. Unplug all cables from the power outlets.
3. Place the enclosure on a flat, stable surface.
4. Observe ESD precautions when handling a system component.
5. Remove the system cover.
(a) Loosen the two captive screws on the rear of the system cover.
(b) Slide the cover towards the back of the system until the tabs on the cover disengage with the
slots on the unit.
(c) Lift the cover to remove it, then set it aside.
6. Remove the drive from the drive bay.
CAUTION: When pulling out the hard drive using the mounting rails handle, use your hand to
support it from underneath so it does not fall.
(a) Pull on the center of the mounting rails handle and move the assembly from side to side to
disengage the side latches. Carefully slide the drive forward approximately 1 inch from its bay.
(b) While pulling out the drive assembly with one hand, use your other hand to support the drive
while sliding it out of the enclosure.
WD SHARESPACE
USER MANUAL
REPLACING A DRIVE - 91