Western Digital ShareSpace User Manual page 47

To restore the device to factory defaults:
Performing a factory default reset will erase all settings in the network storage
system. System configuration will reset the device to default factory settings. All
information and data will be lost. The LAN settings (including port settings) are not
changed. After the reset, the administrator login/password will be changed to
"admin/admin."
Important: Save the current configuration prior to restoring the factory
default settings.
1. On the Configuration Management page, click Factory Default Restore.
2. Click OK.
During the system restore process, the system will turn off power LED and blink
backup LED. Wait until the system restore process is completed.
Note: You cannot access the configuration web pages if you forget the administrator password, IP
address setting, or device name. Use the reset button to restore these settings (including IP setting,
device name and administrator password) to factory default configuration. To use this function, press
and hold the reset button on the back of the device (next to power interface) for at least 10 seconds.
The system reboots automatically and you can then use the default settings to access the device.
Advanced
Configure the device's identification LED, and configure the system for a secure
connection by generating a key and an SSL certificate automatically or manually
using the Advanced menu. System Identification identifies the location of the device.
If you have multiple devices installed, you can use this function to turn on the
identification LED and know which device you are configuring.
If the HDD Standby function is enabled, the hard drives go into standby mode to save
power after a fixed period of no activity. This period varies from 125 seconds to 375
seconds.
Note: The fan will continue to operate even when the hard drive(s) spin down in standby mode.
WD SHARESPACE
USER MANUAL
NETWORK STORAGE MANAGER - 42